Enabling Replaced Components In The Bios - Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual

Enabling the boot watchdog in the BIOS
▶ Enter the BIOS.
▶ Select the Server Mgmt menu.
▶ Under Boot Watchdog set the Action setting to Reset.
▶ Save your changes and exit the BIOS.
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
Enabling the boot watchdog using the iRMC S6 web interface
▶ Log in to the iRMC S6 web interface.
▶ Select the Settings menu.
▶ Open the Server Management page.
▶ In the Boot Watchdog group, check the Enable Boot Watchdog option.
The Enable Boot Watchdog option must be selected.
▶ Select Reset from the Watchdog Action list.
▶ Click Apply for the changes to take effect.
For more information on iRMC settings, see the iRMC user guides.
5.3.7

Enabling replaced components in the BIOS

When a CPU, an expansion card, or a memory module fails, the defective
component will be set to Disabled or Failed in the BIOS. The server will then
reboot with only the intact hardware components remaining in the system
configuration. After replacing the defective component, it needs to be
reenabled in the BIOS.
▶ Enter the BIOS.
▶ Select the Advanced menu.
RX1330 M5 Upgrade and Maintenance Manual
Basic software procedures
81