Pentair FLECK 3150 NXT Installer Manual page 96

Installer manual Fleck 3150 NXT/NXT2 - Programming
Parameter
AUX. 2:
VOLUME BASED
- DURATION
PUSH
SETTINGS
SAVE AS NON-
FACTORY
LOCK
SETTINGS
6.2.5.2 Entering master programming mode
a) Press and hold
two seconds to enter the master programming mode;
b) Set the password using
ð If the controller calls for a Password that is
unknown to you, please contact your installer.
6.2.5.3 Settings review
Activate or deactivate the settings review mode.
Options:
• on: all parameters and current programming can be displayed but not modified;
• off: all parameters are displayed and programmable.
a) Adjust the time with
b) Press
next parameter.
6.2.5.4 Language setting
Select the displayed language.
Options:
96 / 182
Options
1 to 7200
ON
OFF
ON
OFF
OFF
DELAYED
ENTER
CODE
TIME
BASED
and simultaneously for
,
and
to validate the selection and advance to the
Definition
Second Only displayed if "volume based"
is chosen for auxiliary 1;
Volume range depend on
capacity;
Even if maximum theoretical
programmable value is 9999 the
controller will take 7200 as
duration.
(default) Only displayed for multi unit
systems.
-
- The non-factory configuration
can be used on RESET.
(default)
(default) Lock setting prevents
unexpected access to master
-
programming.
-
-
and ;
.
Ref. MKT-IM-010 / C - 18.10.2019
Note
If lock settings is
activated.