Pentair FLECK 3150 NXT Installer Manual page 112

Installer manual Fleck 3150 NXT/NXT2 - Programming
Cycle based
Set the cycle based relay output during regeneration.
Info
Only visible if "cycle based" was selected as auxiliary in the previous step.
a) Choose the options of relay with
ð Unselected cycle are marked by
ð Activated cycles are marked with a
ð Multi-selection is possible;
b) Press
next parameter.
Time based
Set the time based relay output during regeneration.
Info
Only visible if "time based" was selected as auxiliary in the previous step.
Info
This parameter has two steps of settings for each time Start time # / End time#. The
first one activates the relay output, and the second one deactivates the relay output.
The time 0 MIN corresponds to the beginning of regeneration time. If the first interval
of activation does not cover the whole regeneration duration, it is possible to set up a
second interval.
a) Set the relay Start time #1 with
b) Can be adjusted from:0 to the total regeneration
duration minus 1 minute;
c) Press
next parameter.
d) Set the relay End time #1 with
e) Can be adjusted from: start time #1 + 1 to the total
regeneration time, in minutes;
f) Should the End time#1 be shorter than the total
regeneration duration, a second interval may be
programmable in the remaining period of regeneration,
provide this remaining period is long enough to allow
activation/deactivation of the relay (minimum 2 minutes
are required).
g) Press
next parameter;
112 / 182
to validate the selection and advance to the
to validate the selection and advance to the
to validate the selection and advance to the
and ;
;
;
and ;
and ;
Ref. MKT-IM-010 / C - 18.10.2019
Activated during selected
cycle step.
Activated as of the
regeneration starts.
TIME BASED - START
TIME #1.
Deactivated 10 minutes
after the regeneration
started.
TIME BASED - END
TIME #1.