Pentair FLECK 3150 NXT Installer Manual page 64

Installer manual Fleck 3150 NXT/NXT2 - Programming
6.1.5 Master programming mode
Info
As soon as programming mode is entered, all parameters can be displayed or set to
suit the needs. Depending on the current programming, some functions will not be
displayed or will not be changeable.
Info
If none of the buttons are pushed for 5 minutes in the Programming mode, or if there is
a power failure, the controller returns to Service mode without saving.
Mandatory
In order to store the new settings in the programming mode, it is necessary to go
through all the parameters.
6.1.5.1 Master programming mode chart
Parameter
LANGUAGE
SYSTEM TYPE
VALVE
ADDRESS
SYSTEM SIZE
64 / 182
Options Definition
ENGLISH English
FRANCAIS French
DEUTSCH German
ITALIANO Italian
ESPANOL Spanish
4 Single unit
5 Parallel interlock
6 Parallel series
regeneration
7 Alternating immediate 2 units.
9 Parallel with standby
14 On-demand
#1 First control valve
#2 Second control valve
(default)
#3 Third control valve
#4 Fourth control valve
2 2 valves in the system This screen will not be displayed
3 3 valves in the system
4 4 valves in the system
1 unit.
2 to 4 units.
2 to 4 units.
unit
This screen will not be displayed
for system type 4.
for system type 4.
Ref. MKT-IM-010 / C - 18.10.2019
Note