Installer manual Fleck 3150 NXT/NXT2 - Programming
6.1.6
Diagnostic
Info
Depending on current settings, some displays cannot be viewed.
Info
There is no time limit on the displays in the Diagnostic mode.
6.1.6.1
Commands
a) Press D to enter the Diagnostic mode.
b) Press
c) Press D to exit the Diagnostic mode at any time.
6.1.6.2
Current flow rate
Info
The display is updated every second.
6.1.6.3
Peak flow rate
Info
The controller registers the highest flow rate since the last regeneration.
6.1.6.4
Totalizer
Info
The controller registers the total volume of treated water that passes through the
meter since start-up (or last hard reset).
a) To reset, press and hold the buttons
5 seconds until the display shows zero.
78 / 182
to pass at the next step.
and
for
Ref. MKT-IM-010 / C - 18.10.2019