Table of Contents
Advertisement
a) Set the remote controller with
ð Can be adjusted from OFF to 01:39:00.
b) Press
next parameter.
6.1.5.11 Display format
Set the unit system to be used.
Options:
• US GALLONS: volume in gallons, time display 2 x 12 hours, hardness in grains;
• EU-METRIC-LITERS: volume in liter, time display 24 hours and hardness depends
on the language:
EN: mg/L as
CaCO
a) Set the display format with
b) Press
next parameter.
6.1.5.12 System capacity
Set the capacity of the tank where the valve is installed.
Info
Based on system capacity, safety coefficient and inlet water hardness, the controller
calculates the volume of water that the system can treat between 2 regenerations.
a) Set the unit capacity with
b) Press
next parameter.
This volume corresponds to the volume the tank could treat
if the inlet water hardness is 1°F, 1°TH or 1°dH.
6.1.5.13 Safety coefficient
Set the percentage value by which the total capacity is reduced as a safety coefficient.
Ref. MKT-IM-010 / C - 18.10.2019
to validate the selection and advance to the
FR: °F
3
to validate the selection and advance to the
to validate the selection and advance to the
Installer manual Fleck 3150 NXT/NXT2 - Programming
,
and
.
GE: °dH
and
.
,
and
.
Without remote
controller.
With remote controller
and 1 minute contact
programmed.
IT: °TH
SP: °TH
Example: 3000 g of
CaCO
of capacity.
3
71 / 182
Hide quick links:
Advertisement
Table of Contents
