Pentair FLECK 3150 NXT Installer Manual page 87

Info
This parameter is visible only in "Softener meter immediate/delayed " mode
a) Adjust the volume with
b) Press
next parameter.
6.2.4.6 Push settings
This parameter allows to push and copy settings from the master unit to all other
connected units.
Info
This parameter is visible only in multi-units systems.
a) Select OFF or ON with
b) Press
6.2.5 Master programming mode
Info
As soon as programming mode is entered, all parameters can be displayed or set to
suit the needs. Depending on the current programming, some functions will not be
displayed or will not be changeable.
Info
If none of the buttons are pushed for 5 minutes in the Programming mode, or if there is
a power failure, the controller returns to Service mode without saving.
Mandatory
In order to store the new settings in the programming mode, it is necessary to go
through all the parameters.
6.2.5.1 Master programming mode chart
Parameter
SETTINGS
REVIEW
Ref. MKT-IM-010 / C - 18.10.2019
Installer manual Fleck 3150 NXT/NXT2 - Programming
,
to validate the selection and advance to the
and
to validate the selection.
Options
ON
OFF
(Default)
and .
.
Definition
- When settings review mode is
on, no programming changes
-
can be done.
Note
87 / 182