Pentair FLECK 3150 NXT Installer Manual page 104

Installer manual Fleck 3150 NXT/NXT2 - Programming
a) Set the safety coefficient with
ð Can be adjusted from 0 to 50%;
ð Any value programmed above the maximum value
will be discarded and considered as the maximum
above mentioned value.
b) Press
next parameter.
Fixed volume
Set a fixed volume as safety reserve capacity.
Info
The availability depends on reserve type programmed in the previous step.
a) Set the reserve volume with
ð The volume range depend on capacity, in liter if
metric units were programmed or US gallon if US
units were programmed (see Units [}Page 101] );
ð The maximum reserve volume capacity settable
will correspond to the half of the total volume.
b) Press
next parameter.
6.2.5.19 Remote regeneration
Set the regeneration type for remotely started regeneration (external dry contact input,
see chapter Electrical connections [}Page 52]).
Info
This mode can be combined with the other methods of regeneration; the remotely
started regenerations overrule the other regeneration type once the signal is acquired.
Options:
• off;
• immediate;
• delayed.
a) Set the remote regeneration mode with
ð Default setting: off;
b) Press
next parameter.
104 / 182
to validate the selection and advance to the
to validate the selection and advance to the
to validate the selection and advance to the
, and ;
, and ;
and ;
Ref. MKT-IM-010 / C - 18.10.2019
No safety factor
programmed.
Remote regeneration
deactivated.