Pentair FLECK 3150 NXT Installer Manual page 106

Installer manual Fleck 3150 NXT/NXT2 - Programming
6.2.5.22 Day override/time driven
Set the maximum number of days between two regenerations regardless from any
other regeneration triggering type that could be programmed.
Info
For a timeclock valve, this value must be set as regeneration period in hours or days.
Info
For metered valves, this value can be set in days only.
Info
Not available if the regeneration type programmed is Day of week mode.
a) Adjust the number of days with
ð Can be adjusted with 4H, 8H, 12H, 16H, 20H or
from 1 to 99 days for timeclock regeneration and
from OFF to 99 days for metered regeneration;
b) Press
next parameter.
6.2.5.23 Regeneration time
Set the time for regeneration start.
Info
Depending on regeneration mode programmed, this parameter may be displayed or
not.
a) Adjust the time of regeneration with
b) Can be adjusted from: 00:00 to 23:59HR;
c) Press
next parameter.
6.2.5.24 Lock setting
Set Lock Window settings: Enable lock windows then select the desired Lock Start time
and Lock End time.
106 / 182
to validate the selection and advance to the
to validate the selection and advance to the
and ; Calendar override
deactivated.
Override every 3 days.
, and ;
Ref. MKT-IM-010 / C - 18.10.2019