Pentair FLECK 3150 NXT Installer Manual page 95

Parameter
AUX. 2: CYCLE
BASED
AUX. 2: TIME
BASED - START
TIME #1
AUX. 2: TIME
BASED - END
TIME #1
AUX. 2: TIME
BASED - START
TIME #2
AUX. 2: TIME
BASED - END
TIME #2
AUX. 2:
VOLUME
BASED –
VOLUME - L
Ref. MKT-IM-010 / C - 18.10.2019
Installer manual Fleck 3150 NXT/NXT2 - Programming
Options Definition
SP Service position
BW Backwash position
BD Draw and slow rinse
position
RR Rapid rinse position
RF Refill position
SB Pause position
0 to total Minute
regeneratio
n time
minus
1 minute
from start Minute
time#1 plus
1 minute
until total
regeneratio
n duration
OFF Minute
End time #1
to total
regeneratio
n duration
minus
1 minute
OFF Minute
From start
time #2
+ 1 minute
until the
total
regeneratio
n duration
0 to MAX
Only displayed if "Cycle based"
is chosen for auxiliary 2;
Activate or de-activate for each
position (
= activated).
Only displayed if "Time based" is
chosen for auxiliary 2.
Only displayed if "Time based" is
chosen for auxiliary 2 and END
TIME #1< total regeneration
duration minus 1 minute;
Range depend on Start and end
time #1 values.
Only displayed if "Time based" is
chosen for auxiliary 2 and START
TIME #2 ON;
Range depend on Start and end
time #1 values.
Liter Only displayed if "volume based"
is chosen for auxiliary 1;
Volume range depend on
capacity;
Even if maximum theoretical
programmable value is 999999
the controller will take the unit
capacity as maximum volume.
Note
= deactivated;
95 / 182