Nortel Succession 1000 Installation And Configuration Manual page 89

Table 9
General purpose commands (Part 2 of 3)
IPL> command
ping "host",
"numpackets"
itgCardShow
itgMemShow
ifShow
IPInfoShow
swVersionShow
isetShow
isetShowByTN
isetShowByIP
Command line interface (CLI) commands
Description
Sends an ICMP ECHO_REQUEST packet to a
network host. The host matching the destination
address in the packets responds to the request. If a
response is not returned, the sender times out. This
command is useful to determine if other hosts or
Voice Gateway Media Cards are communicating
with the sender card. The "numpackets" parameter
specifies how many packets to send. If it is not
included, ping runs until it is stopped by Ctrl-C (also
exits the IPL> Command Line Interface).
Example:
IPL> ping "47.82.33.123", 10
Displays Voice Gateway Media Card information.
Displays memory usage.
Displays detailed IP address information, including
MAC addresses.
Displays IP address information.
Displays software version.
Displays general information for all registered
Internet Telephones. For example, the command
displays the IP address of the Internet Telephone,
the VTN that the Internet Telephone is associated
with, indicates the type of Internet Telephone such
as i2001, i2002, i2004, CPVIP, or i2050, and
provides the type of registration and the new
registration status.
Displays general information about all registered
Internet Telephones, sorted by TN.
Displays general information about all registered
Internet Telephones, sorted by IP address.
Signaling Server
Page 89 of 116
Element
Manager
Installation and Configuration
!
!
!