Nortel Succession 1000 Installation And Configuration Manual page 85

Importing and upgrading an IP Trunk node
To work with IP Trunk nodes, the IP Trunk cards must first be converted to
Voice Gateway Media Cards. They can then be added to new and existing
IP Telephony nodes. To import and upgrade an IP Trunk node to an
IP Telephony Node, refer to Succession 1000 System: Upgrade Procedures
(553-3031-258), Large System: Upgrade Procedures (553-3021-258), or
Small System: Upgrade Procedures (553-3011-258).
Reviewing and submitting IP Telephony node configuration
Use this procedure to review IP Telephony node configuration before
submitting. If the configuration is correct, they data can be submitted.
Transferring IP Telephony files
Use this procedure whenever you change the IP telephony node
configuration. This procedure transfers the node data files to the other nodes
in the system. You can transfer the data files to one, many, or all other nodes
in the system.
Note: After completing this procedure, reboot the Succession Signaling
Server if you changed its configuration.
Backing up IP Telephony node configuration files
Use this procedure as an alternative to the EDD command in LD 43 to
perform a data dump. The data dump backs up new and updated IP Telephony
node files on the Succession Call Server at the same time as it backs up the
customer database.
IP Telephony node configuration
Signaling Server
Page 85 of 116
Installation and Configuration