Nortel Succession 1000 Installation And Configuration Manual page 113

Procedure 13
Verifying a successful memory upgrade
1 Connect a standard serial interface (straight-through) cable to the
maintenance terminal and to the serial port on the back (not the front) of
the Succession Signaling Server.
2 Using a terminal software program, such as Microsoft Windows
HyperTerminal, configure the terminal type of the maintenance terminal
serial port to "auto detect" terminal type.
3 Connect the power cable to the Succession Signaling Server.
4 Press the power switch, the left-most button on the front of the
Succession Signaling Server.
The following should appear on the maintenance terminal screen:
AMIBIOS (C)2001 American Megatrends Inc.
Copyright 1996-2001 Intel Corporation
TR440BXA.86B.0042.P15.0107200951
Intel(R) Pentium(R)III processor, 700MHz
512MB OK
Hit <F2> if you want to run SETUP
5 <Optional> To do a more detailed memory test:
a. Press the F2 button.
b. Navigate to the "Boot" menu.
c. Disable the Quickstart option.
d. Exit, saving the changes.
Do not change any other settings. The Succession Signaling Server
reboots and performs a more detailed memory test at boot time.
If "512MB OK" appears on the screen, the memory upgrade has been
successful. If not, the memory upgrade has failed.
6 Power off the Succession Signaling Server by depressing the Power
button for seven seconds.
7 Disconnect the power cable.
Appendix A: Upgrading memory
End of Procedure
Signaling Server
Page 113 of 116
Installation and Configuration