The Succession Signaling Server LED indicators show the following:
•
•
•
•
•
Note: When the power is turned off on a Succession Signaling
Server, the two Link LEDs for Port 0 and Port 1 continue to flash.
Depress the Power button for approximately seven seconds to
completely turn the power off.
7
Refer to the Succession Signaling Server Product Guide on the resource
CD-ROM shipped with the Succession Signaling Server for additional
operating information.
Maintenance terminal configuration parameters
This section contains the parameters for configuring a maintenance terminal
for use with the Succession Signaling Server. Use these parameters in
conjunction with Table 3 on
Power - Green LED on, power on; LED off, power off.
Status - Red LED off, CPU running; LED on, CPU halted.
Drive - Green LED flashing, Hard Drive or CD ROM Drive active.
Link - Green LED, Ethernet port active.
100 Mbps - Green LED on, Ethernet port running at 100 Mbps;
LED off, Ethernet port running at 10 Mbps.
End of Procedure
page
Signaling Server
Hardware installation
44.
Installation and Configuration
Page 49 of 116