Nortel Succession 1000 Installation And Configuration Manual page 79

Procedure 7
Logging in to the Succession Signaling Server
Before you begin, make sure the DTE–DTE null modem cable (supplied with
the Succession Signaling Server) runs between the serial port on the back of
the Succession Signaling Server and the maintenance terminal.
1 Make sure the Succession Signaling Server is powered up and connected
to the maintenance terminal. Refer to Procedure 3 on
The Succession Signaling Server must boot successfully before the user
can log in.
2 Press <cr > to invoke the login prompt.
3 Enter the login credentials.Succession Signaling Server Command Line
Interface (CLI) user name.
Note: If the Succession Signaling Server has connected to the
Succession Call Server (the startup messages indicate if the PBX link is
up), use the PWD1 login to access the Succession Signaling Server.
a. Enter the default Succession Signaling Server Command Line
Interface (CLI) login
b. Enter the Succession Signaling Server Command Line Interface
(CLI) password.
• If this Succession Signaling Server has just been installed and
you are logging in for the first time, enter the default password
cseadmin.
The system immediately prompts you to change the default
password.
• If this is not the first login to the Succession Signaling Server,
enter the appropriate password.
If you have forgotten the password, reset it from the Tools Menu
(see Procedure 9 on
To log out of the Succession Signaling Server, enter
line.
Software installation
admin.
page 101).
End of Procedure
Signaling Server Installation and Configuration
Page 79 of 116
page 44.
at the command
exit