Nortel Succession 1000 Installation And Configuration Manual page 70

Page 70 of 116 Software installation
Figure 34
Leader/Follower Succession Signaling Server configuration
Succession Enterprise Software Signaling Server Install Tool (sse-x.xx.xx)
=====================================================================
In this step, you define the role of this Signaling Server.
If you set this Signaling Server as a Leader, then data networking
and IP Telephony parameters must be entered now. (This will pre-
configure the IP Telephony node files.)
If you set this Signaling Server as a Follower, then data networking
and IP Telephony parameters must be configured through Element
Manager.
NOTE: This will over-write all existing data network and IP
telephony configuration on this Signaling Server.
Please enter:
<CR> -> <a> - Set this Signaling Server as a Leader.
<b> - Set this Signaling Server as a Follower.
<q> - Quit.
Enter Choice>
553-3001-212 Standard 1.00
9 If this is a new installation, configure the Succession Signaling Server as
Leader or Follower. See Figure 34 on
• If there is not already a Leader Succession Signaling Server in the
IP Telephony node, enter 'a' at the prompt to configure this
Succession Signaling Server as Leader. Then go to step 10 on
page 71
• If there is already a Leader Succession Signaling Server in the
IP Telephony node, enter 'b' at the prompt to set this Succession
Signaling Server as Follower. Then go to step 15 on
Figure 40 on
For more information about Leader and Follower Succession Signaling
Servers, see IP Line: Description, Installation, and Operation
(553-3001-365) and Succession 1000 System: Overview
(553-3031-010).
Figure 36 on page 72
configuration data. These screens are prompted one after the other.
October 2003
page 75 appears.
and Figure 37 on
page 70.
page
page 73 also show required
74.