Nortel Succession 1000 Installation And Configuration Manual page 56

Page 56 of 116 Software installation
Succession Signaling Server Software CD-ROM
553-3001-212 Standard 1.00
To perform a software installation or upgrade, reboot the Succession
Signaling Server with the Software CD-ROM in its drive. No floppy disk is
required, since the software CD-ROM is bootable.
The Install Tool installs all Succession Signaling Server software, including
the operating system, applications, and web files. The Install Tool also copies
software files for the Voice Gateway Media Cards (VGMCs) and Internet
Telephones, which are used to upgrade these components. For a new
Succession Signaling Server, the Install Tool prompts for IP Telephony
parameters to perform basic system configuration.
After installing the Succession Signaling Server software and configuring
basic information about the Succession Signaling Server, the Succession
Signaling Server components can be configured using the web-based
Element Manager interface. Refer to Succession 1000 Element Manager:
System Administration (553-3001-332).
If you do not have the latest version of the CD-ROM:
• Order or download the CD-ROM image from the Nortel Networks
Electronic Software Download site. See Procedure 4 on
instructions on downloading the image.
• Create the Install Tool CD-ROM from the image. See Procedure 5 on
page 57.
A single ".iso" file is provided to create the Software CD-ROM. This file is a
ready-to-burn ISO9660 CD image that creates a bootable CD that complies
to the El Torito specification. You must use CD writer software that can
create a CD from this image. As the CD image is pre-configured, your
software automatically creates a bootable Succession 3.0 Software
CD-ROM. See your software's help pages to create a CD from an ISO file.
Also review the associated README file that is associated with the Nortel
Networks Succession Signaling Server Software download.
October 2003
page 57 for