Nortel Succession 1000 Installation And Configuration Manual page 59

2 Insert the Software CD-ROM into the Succession Signaling Server CD
drive, and press the RST button on the front panel to cold-reboot the
Succession Signaling Server.
Note: The Software CD-ROM should be bootable. If not, create a boot
floppy using the files in the /mkboot directory on the Succession
Signaling Server Software CD-ROM.
3 If this is a software upgrade or a re-installation on an existing system,
observe the boot sequence. Enter 'c' at the boot menu shown in Figure 20
on page 59.
Note: Entering 'c' at the "ISP 1100 System Boot" banner speeds up this
process, as the keyboard input is buffered.
Figure 20
Upgrade boot sequence
ISP 1100 Boot
Copyright 2003 Nortel Networks, Inc.
CPU: PC PENTIUM
Version: x
BSP version: 1.2/0
Creation date: May 31 2002, 15:44:38
ataDrv 1.0: ATAPI Drive Found
Controller 1 drive 0
Controller 1 drive 1
ATAPI Controller 1 #drives found = 1
Read boot parameters from:
[C]DROM
[H]ard Disk
5 [H]
Note: If you do not select 'c' within the 5-second time-out, the
Succession Signaling Server boots to the existing software on the hard
disk.
4 When the Install Tool banner appears (Figure 21 on
<CR> to perform system checks and begin software installation.
Software installation
Signaling Server Installation and Configuration
Page 59 of 116
page 60), press