Appendix A: Upgrading Memory; Contents; Introduction - Nortel Succession 1000 Installation And Configuration Manual

Appendix A: Upgrading memory

Contents

Introduction

This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Upgrading the memory . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Verifying a successful memory upgrade. . . . . . . . . . . . . . . . . . . . . . . .
For capacity reasons, the memory on the Succession Signaling Server has
been increased from 256MB to 512MB. 256MB is more than sufficient for
Succession 1000 Release 1.0 and 2.0 systems in smaller environments (less
than 5000 Internet Telephones).
This change is effective on all Succession Signaling Servers shipped with
Succession 3.0 Software. To enable customers to redeploy their current
NTDU27AA 01, 02 or 03 Succession Signaling Servers into a large
Succession 3.0 environment, a Succession Signaling Server Memory
Upgrade Kit (NTDU80CA) is available. This section explains how to
upgrade the memory using this kit.
Note: These instructions are intended for qualified technical personnel
with experience installing and configuring servers.
Signaling Server Installation and Configuration
Page 105 of 116
105
106
108
112