Nortel Succession 1000 Installation And Configuration Manual page 45

Figure 13
Maintenance to Succession Signaling Server connection
Maintenance Terminal
3 Connect a maintenance terminal to the Succession Signaling Server.
a. Connect a DTE–DTE null modem serial cable (supplied with the
Succession Signaling Server) from the Serial Port on the back of the
Succession Signaling Server to a maintenance terminal. The
connection looks like that shown in Figure 13.
Serial Cable
b. Set the COM port on the maintenance terminal as follows:
• Terminal type: VT100
• Speed: 19 200
• Data bits: 8
• Parity: none
• Stop bits: 1
• Flow control: none
Note: The Succession Signaling Server is shipped with the Admin/
Serial port set to 19 200 Bit/s. Other available speeds are 9600,
38 400, and 115 200 Bit/s. Once the Succession Signaling Server
software has been installed, the port speed can be changed using the
Tools Menu on the Succession Signaling Server Install Tool. See
Procedure 11 on
4 Configure the maintenance terminal.
The maintenance terminal can be configured any time, except during data
transmission. Do not configure the terminal during data transmission to
avoid data loss.
Hardware installation
Signaling Server
page 103.
Signaling Server
Page 45 of 116
Succession
553-AAA0103
Installation and Configuration