Nortel Succession 1000 Installation And Configuration Manual page 58

Page 58 of 116 Software installation
Installing the software
553-3001-212 Standard 1.00
3 Label the CD appropriately, for example, Succession Signaling Server,
sse-x.xx.xx.
The Software CD-ROM must be readable in a standard CD-ROM drive. After
you create a CD from the CD image, the CD contains several directories and
files. If you cannot create a CD, refer to the CD writer's software
documentation.
Once the CD is created, you can use it to install new software or upgrade
software on an existing Succession Signaling Server.
Before proceeding, you must complete Procedure 3 "Connecting and
powering up the Succession Signaling Server" on page 44.
Procedure 6
Installing the Succession Signaling Server software
After you complete step 1 below, this procedure takes approximately 15
minutes.
1 From your Planning and Engineering group, obtain the following network
and IP Telephony data for this Succession Signaling Server:
• node ID for the IP Telephony node
• node IP address for the IP Telephony node
• hostname for the Succession Signaling Server
• ELAN IP address, subnet mask, and gateway
• TLAN IP address, subnet mask, and gateway
• ELAN IP address of the Succession Call Server
• Gatekeeper role [refer to IP Peer Networking (553-3001-213) for
details on the Gatekeeper]
• primary and alternate Gatekeeper IP addresses for this networked
system (refer to IP Peer Networking (553-3001-213))
October 2003
End of Procedure