Upgrading The Memory - Nortel Succession 1000 Installation And Configuration Manual
Signaling server
Hide thumbs
Also See for Succession 1000:
- Description, installation and operation manual (646 pages) ,
- Features and services fundamentals (616 pages) ,
- Fundamentals (492 pages)
Table of Contents
Advertisement
Page 108 of 116
Upgrading the memory
553-3001-212
Standard 1.00
Appendix A: Upgrading memory
To upgrade the memory of the Succession Signaling Server, perform the
following:
1
Remove the cover of the Succession Signaling Server.
2
Remove the existing DIMM boards.
3
Insert the new DIMM boards.
4
Replace the cover on the Succession Signaling Server.
These steps are described in Procedure 12.
Procedure 12
Upgrading the Succession Signaling Server memory
1
Remove the cover from the Succession Signaling Server. Refer to
Figure 45 on
page
a.
Use a Phillips screwdriver to remove the screw (A) from the front
edge of the cover.
b.
Grasp the back edge of the cover. Simultaneously, pull from the back
edge and push near the front edge until the cover slides out from
under the edge of the Succession Signaling Server front panel.
c.
Grasp the notch (B) in the front center of the cover and lift up to
remove the cover.
October 2003
109.
Advertisement
Table of Contents
