Figure 6
Chassis support bracket
3
Align the screw holes in the rack-mount rail to the mating holes in the side
of the Succession Signaling Server chassis. Use three screws (C) on
each side.
Note: Hand-tighten the screws to prevent cross-threading, then use a
Phillips screwdriver to secure them.
4
Attach the bezel door to the faceplate of the Succession Signaling Server,
as shown in Figures 7 and 8 on
Hardware installation
page
38.
Signaling Server
Installation and Configuration
Page 37 of 116
553-AAA0097
553-AAA0097