Verifying A Successful Configuration; Testing The Leader Succession Signaling Server - Nortel Succession 1000 Installation And Configuration Manual

Page 80 of 116 Software installation

Verifying a successful configuration

Testing the Leader Succession Signaling Server

553-3001-212 Standard 1.00
To ensure that the Succession Signaling Server Ethernet connections are
configured correctly (ELAN and TLAN), perform a ping test to one or more
of the other devices connected to the network, particularly the Succession
Call Server.
Procedure 8
Verifying the Succession Signaling Server Ethernet connection
1 Log in to the Succession Signaling Server, using Procedure 7 on
page 79.
2 Ping the IP address of the Succession Signaling Server. Enter the
command:
ping x.x.x.x
Where x.x.x.x is the Succession Signaling Server ELAN IP address.
3 Ping the IP address of the Succession Call Server. Enter the command:
ping x.x.x.x,3
Where x.x.x.x is the Succession Call Server ELAN IP address.
4 If desired, repeat step 3 for other devices connected to the network.
Configure two Internet Telephones to register to the Succession Signaling
Server on its temporary node. These Internet Telephones have to be
provisioned on the Succession Call Server. Refer to Succession 1000 System:
Installation and Configuration (553-3031-210), Large System: Installation
and Configuration (553-3021-210), or Small System: Installation and
Configuration (553-3011-210) for the procedure appropriate to the system.
After provisioning, the telephones can call each other.
October 2003
End of Procedure