Nortel Succession 1000 Installation And Configuration Manual page 40

Page 40 of 116 Hardware installation
Rack-mounting
553-3001-212 Standard 1.00
Read the following warnings carefully before installing the Succession
Signaling Server in the rack.
DANGER OF ELECTRIC SHOCK
DISCONNECT AC POWER
Make sure the Succession Signaling Server is
completely disconnected from any AC power source
before performing this procedure. Pressing the Power
button DOES NOT turn off power to this Succession
Signaling Server. Some circuitry in the Succession
Signaling Server can continue to operate even though
the front panel Power button is off. Failure to disconnect
the Succession Signaling Server from its AC power
source can result in personal injury or equipment
damage.
DANGER OF ELECTRIC SHOCK
GROUNDING THE RACK INSTALLATION
To avoid the potential for an electrical shock hazard,
include a third wire safety grounding conductor with the
rack installation. If Succession Signaling Server power
cords are plugged into AC outlets that are part of the
rack, then provide proper grounding for the rack itself. If
Succession Signaling Server power cords are plugged
into wall AC outlets, the safety grounding conductor in
each power cord provides proper grounding only for the
Succession Signaling Server. Provide additional, proper
grounding for the rack and other devices installed in it.
October 2003