Nortel Succession 1000 Installation And Configuration Manual page 64

Signaling server
Table of Contents

Advertisement

Page 64 of 116
Software installation
Figure 25
Hard disk test
Succession Enterprise Software Signaling Server Install Tool (sse-x.xx.xx)
=====================================================================
The Install Tool cannot determine when the hard disk was last tested.
The hard disk must be tested before installation can continue.
This test will take approximately 14 minutes.
Please enter:
<CR> -> <a> - Test the hard disk.
Enter Choice> a
Figure 26
Not recently tested
Succession Enterprise Software Signaling Server Install Tool (sse-x.xx.xx)
=====================================================================
The Install Tool has detected that the hard disk has not been tested
recently.
It is recommended to test the hard disk now. This test will take
approximately 14 minutes.
Please enter:
<CR> -> <a> - Test the hard disk.
<b> - Skip the hard disk test.
Enter Choice> a
553-3001-212
Standard 1.00
If the hard disk has not recently been tested, enter 'a' at the menu
shown in Figure 26.
If the hard disk has been checked in the last 24 hours, enter 'a' at the
menu shown in Figure 27 on
October 2003
page
65.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Succession 1000m

Table of Contents