Steps
Hold the expansion card by the edges and pull it to disengage from the connector .
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 50. Removing an expansion card from the riser
Next steps
Install the expansion card into the
Installing the expansion card in to the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4.
Remove the expansion card
Steps
1. If installed, remove the filler bracket.
NOTE:
Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
riser.
Safety
instructions.
Before working on your
riser.
system.
Installing and removing system components
83