Chapter 8: Mil Kit; Installing The Mil Kit - Dell PowerEdge XR7620 Installation And Service Manual

The MIL kit provides rugged protection for the PowerEdge XR7620 server. The MIL kit consists of the components mentioned
below:
● Power supply rugged bracket
● Drive rugged bracket
● Ten countersunk screws
Topics:
•

Installing the MIL kit

Installing the MIL kit
Prerequisites
NOTE: The MIL kits are ordered separately from Dell.
1. Follow the safety guidelines listed in the
2. Unpack the 901E and MIL 461G rugged brackets.
3. If installed, remove the front
4. Remove the front bezel
Steps
1. Align and slide the storage MIL bracket on the drive cage. Using a Phillips 1 screwdriver, tighten the screws securing the
storage MIL bracket on the drive cage.
Figure 172. Installing the storage MIL bracket
2. Align the power supply bracket to the rear of the power supply cage and slide it in to secure it in place. Using a Phillips 1
screwdriver, secure the power supply rugged bracket.
196 MIL kit
Safety instructions.
bezel.
for Front Accessed configuration.
8
MIL kit