Adding Ipsi Information - Avaya S8700 Series Manual

2. Verify that the Primary Control Subnet Address and Secondary Control Subnet
Address (if equipped) fields are correct.
The subnet addresses must match the most significant 3 octets (the first 3 groups of digits
in the subnet address) of the Server IP address filled in on the control network entry from
the filled-out Electronic Preinstallation Worksheet (EPW).
An Asterisk (*) to the right of the Subnet Address field means that although a subnet
address is displayed, it is not the correct one; the Communication Manager call processing
software does not have the subnet information. After verifying the displayed information,
submit this form with or without changes to update the Communication Manager with the
correct subnet information.
!
CAUTION:
If the information displayed in the Primary Control Subnet Address and/or
CAUTION:
Secondary Control Subnet Address fields is not correct, it must be changed on
the media servers. Use the Maintenance Web Interface; under Server
Configuration and Upgrades, click Configure Server to change the media server
configuration. Then return here to perform this step.
3. Verify that the Switch Identifier is set correctly for this installation. It is critical that the correct
Switch Identifier is entered here before TN2312 IPSI circuit packs are administered.
4. Verify that the IPSI Control of Port Networks: field is set to disabled.
5. Press Enter to submit the form.
Note:
The information you provide differs, depending on whether the IPSIs get static
Note:
addresses or they are assigned automatically through DHCP.

Adding IPSI information

To add IPSI information:
1. Type add ipserver-interface PNnumber where PNnumber is the port network
number and press Enter to add the IPSI circuit pack information.
Migrating translations
Issue 4 January 2005 53