Restoring The Translations; Pre-Testing The System - Avaya S8700 Series Manual

Migrating from an S8500 Media Server to S8710 Media Server

Restoring the translations

To restore the translations to the active media server:
1. Connect the compact flash reader cord to either USB port on the back of the media server.
2. Insert the compact flash card (used in
translations into the bottom slot of the drive.
3. Under Data Backup/Restore, click View/Restore Data.
4. Select Local PC Card.
Note:
If the laptop is connected to the standby media server, telnet across the
Note:
duplication link to the active media server (telnet 192.11.13.13 is server 1, telnet
192.11.13.14 is server 2. Be sure the translations are copied to the active media
server.
5. Click View.
6. Select the correct translation file (the most recent one) and both Force options.
7. Click Restore.
8. Click Restore History and select desired file.
9. Click Status to view the Restore status. When the restoration is complete, the following
message displays:
Backup: 0: Restore of <filepath/filename> is completed successfully.

Pre-testing the system

To perform pre-testing of the system:
Note:
Do not connect to the control network yet.
Note:
1. Install the license and authorization files.
2. Type reset system 4 and press Enter.
3. Type list station and press Enter.
Verify the same stations are on this server as were on the S8500 Media Server.
4. Type save trans and press Enter.
5. Perform the necessary administration (for example, add duplication administration).
6. When finished, type save trans and press Enter.
148 Migrating to the Avaya S8700 Media Server
Backing up the translation files on page 142) with the