Powering Down The Control Cabinet; Replacing The Processor Circuit Pack - Avaya S8700 Series Manual

Powering down the control cabinet

!
CAUTION:
Make sure you have done the premigration administration. See
CAUTION:
administration (R, SI, CSI)
(S8100)
To power down the control cabinet:
1. Press and hold the shutdown button on the processor's faceplate until the shutdown
process starts.
Make sure you see the green light indicating the system has shut down before continuing.
!
DANGER:
The latch on the power supply acts as the DC power switch and only removes DC
DANGER:
power from the backplane, not the AC power. To remove the AC power from the
cabinet, pull the AC power cord from the back of the cabinet.
2. Power down the cabinet by unplugging the power cord from the back of the cabinet.

Replacing the processor circuit pack

To replace the processor circuit pack:
1. Remove the entire processor circuit pack and place it in an antistatic carrier or bag. You
want it intact if you need to back out of the migration.
2. If csi, remove the TN2182 Tone Clock circuit pack.
3. Remove the octopus cable from the connector associated with slot 2 on the connector
panel.
4. Install the IPSI adapter to the connector associated with slot 2 on the connector panel.
5. Install the maintenance cable onto the 9-pin D-sub connector on the Adapter. This cable is
for emergency transfer and "auxsig" signal.
Note:
The TN2312BP Internet Protocol Server Interface (IPSI-2) circuit pack takes up
Note:
only one slot.
6. Insert the TN2312BP Internet Protocol Server Interface (IPSI-2) circuit pack into slot 2.
7. Attach the new label above the circuit pack slots.
114 Migrating to the Avaya S8700 Media Server
on page 87 if csi or
on page 88 if S8100.
Preconversion
Preconversion administration