Postmigration Administration; Assigning Ip Addresses To The Ipsi Circuit Packs - Avaya S8700 Series Manual

Postmigration administration

This section covers the following tasks:

Assigning IP addresses to the IPSI circuit packs

Verifying IPSI translations
Verifying IPSI connectivity
Enabling control of IPSI(s)
Verifying customer's data
Upgrading firmware (if necessary)
Testing the installation
Busying out trunks
Troubleshooting the migration
Returning replaced equipment
Assigning IP addresses to the IPSI circuit packs
IP server interface circuit packs get IP addresses in one of two ways:
Using dynamic host configuration protocol (DHCP)
Using static IP addressing
The IPSI circuit packs associated with a dedicated control network use the DHCP method. In
rare cases they might use the static addressing method.
The IPSI circuit packs associated with a nondedicated control network use the static addressing
method. In rare cases they might use the DHCP addressing method.
122 Migrating to the Avaya S8700 Media Server
on page 128
on page 129
on page 129
on page 131
on page 132
on page 133
on page 133
on page 133
on page 133
on page 122