Using Dhcp Addressing - Avaya S8700 Series Manual

Migrating
Hide thumbs Also See for S8700 Series:
Table of Contents

Advertisement

Using DHCP addressing

For the TN2312BP IPSI circuit packs to get IP addresses dynamically, you must first assign the
switch ID (A through J) and the cabinet number (01 through 64) to each IPSI circuit pack. For
G650 Media Gateways, a cabinet is defined as one or more media gateways connected by
TDM cable, which is called a G650-rack-mount-stack.
Administering the location assignment
1. Fully insert the TN2312BP IPSI circuit pack. If necessary, reseat the circuit pack to begin
the programming sequence.
Note:
You must do the following steps within 5 seconds after inserting the circuit pack.
Note:
2. Insert a pen, golf tee, or similar object (no graphite pencil) into the recessed push button
switch.
Note:
If you pass up the letter or number that you want, you must either cycle through
Note:
all the letters or numbers to get to the one you want or reinsert (reseat) the circuit
pack and begin again.
CLK
S
E
R
V
Postmigration administration
Issue 4 January 2005
123

Advertisement

Table of Contents
loading

This manual is also suitable for:

S8700S8710

Table of Contents