Chapter 5: IP interface translations
Adding the IPSI to the system
Use the IP Server Interface Administration - Port Network SAT screen to add an IPSI. The
information on this screen differs, depending on whether the IP addresses of the IPSI are static
or assigned automatically through DHCP.
1. Type add ipserver-interface PNnumber and press Enter.
2. For the Host field and the DHCP ID fields for the primary IPSI and secondary IPSI, if any:
For dynamic addressing, the DHCP server sets the Host field and the DHCP ID field.
l
Verify that the fields are populated with default data.
For static addressing, in the Host field, enter the IP address for the IPSI that is listed in
l
the Location field.
add ipserver-interface 8
IP Control? y
Encryption? y
PRIMARY IPSI
Location:
Subnet Mask: /24
IP Address:
SECONDARY IPSI
Location:
Subnet Mask: /24
IP Address:
add ipserver-interface 8
IP Control? y
Encryption? n
PRIMARY IPSI
Location:3A01
Subnet Mask: /24
IP Address:
60 Installing and Configuring the Avaya S8500-Series Server
IP SERVER INTERFACE (IPSI) ADMINISTRATION - PORT NETWORK 8
DHCP? n
5AXX
Gateway:
DHCP? n
5B01
Gateway:
IP SERVER INTERFACE (IPSI) ADMINISTRATION - PORT NETWORK 3
DHCP? No
Gateway:
Ignore Connectivity in Server Arbitration? n
QoS AND ETHERNET SETTINGS
Use System Level Parameter Values? y
QoS AND ETHERNET SETTINGS
Use System Level Parameter Values? y
Ignore Connectivity in Server Arbitration? n
Use System Level Parameter Values? y
Page
1 of
802.1p: 6
DiffServ: 46
Auto? y
802.1p: 6
DiffServ: 46
Auto? y
QoS AND ETHERNET SETTINGS
802.1p: 6
DiffServ: 46
Auto? y
1