Adding The Ipsi To The System; Setting The Alarm Activation Level; Saving Translations - Avaya S8500 Installing And Configuring

Chapter 5: IP interface translations

Adding the IPSI to the system

Use the IP Server Interface Administration - Port Network SAT screen to add an IPSI. The
information on this screen differs, depending on whether the IP addresses of the IPSI are static
or assigned automatically through DHCP.
1. Type add ipserver-interface PNnumber and press Enter.
2. In the Host field, enter the IP address for the IPSI that is listed in the Location field.
add ipserver-interface 8
IP SERVER INTERFACE (IPSI) ADMINISTRATION - PORT NETWORK 8
Ignore Connectivity in Server Arbitration? n
Primary IPSI
------------
Location:
Host: 172.22.22.174
DHCP ID: ipsi-A01a
3. Set the IP Control field to y.
4. Verify that all the other fields are populated and submit the form to save the changes.
5. Repeat this procedure for each port network.

Setting the alarm activation level

1. At the SAT, type change system-parameters maintenance and press Enter.
2. In the CPE Alarm Activation Level field, enter none, warning, minor, or major,
according to the customer request.
3. Submit the screen to save the changes.
4. Repeat this procedure for each IPSI.

Saving translations

To save the translations to the hard disk drive, at the SAT, type save translation and press
Enter.
62
Installing and Configuring the Avaya S8500 Media Server
IP Control? y
1A01
Socket Encryption? n
Enable QoS? n
QoS Parameters
--------------
Call Control 802.1p: 6
Call Control DiffServ: 46
June 2006