Avaya S8700 Series Manual page 124

Setting the switch ID
If you have only one system, the default switch ID is A. The second system would be B and so
on. The switch ID is not the media gateway or carrier letter.
1. While the display is flashing, press the button until the switch ID (A through J) shows on the
top character of the LED display. When the correct letter shows, stop. It will flash a few
times (5 seconds) then stop. The next character down begins to flash.
Setting the cabinet number
The number to program is the cabinet number not the port network number. If you have more
than one IPSI in a cabinet, they all have the same cabinet number.
1. While the first digit of the number is flashing, press the button until the correct tens digit (0
through 6) shows on the display. When the correct digit shows, stop. It flashes a few times
then stops (five seconds). The second digit begins flashing.
2. While the second digit is flashing, press the button until the correct units digit (0 through 9)
shows on the display. When the correct digit shows, stop. The digit flashes a few times then
stops (five seconds).
3. All segments of the display goes dark for one second, and then the Switch ID and media
gateway stack number is displayed in the top three characters of the LED display. A "V" is
shown in the fourth character (bottom) of the display. When the DHCP server assigns an
address to the IPSI, the center of the "V" is filled in to form the bottom half of a diamond in
the display.
For duplicated control network, repeat these steps for the second IPSI in the cabinet.
124 Migrating to the Avaya S8700 Media Server
CLK
S
E
R
V