Migrating From A Definity Ecs R Or Si; Verifying Hardware - Avaya S8700 Series Manual

Migrating from a DEFINITY ECS R or SI

Note:
This section applies to the S8700 or S8710 IP-Connect configuration only.
Note:
These procedures explain how to migrate an existing DEFINITY ECS R or SI to the Avaya
S8700 or S8710 IP Connect configuration. In this migration, you cannot reuse the existing
cabinets; you must move the reusable circuit packs to Avaya G650 Media Gateways.
At this point
The S8700 or S8710 Media Server complex is installed, configured, and operational
The G650 Media Gateways are installed
Any new port circuit packs that were ordered are installed in the media gateways.
This section covers the following tasks:

Verifying hardware

Powering down the cabinets
Removing the circuit packs
Placing circuit packs into G650 Media Gateway
Connecting trunks to PSTN
Connecting the G650 Media Gateways to the Main Distribution Frame
Connecting to the media server
Postmigration administration
Verifying hardware
Make sure you have the migration specific hardware on hand. See
Hardware on page 102 for a list of required hardware. Not all circuit packs can be reused in the
G650 Media Gateway.
packs that can be used with the Avaya G650 Media Gateway.
Circuit Modules
Media Gateway.
In addition, at a presale site inspection, the remediation process must check the vintages of
every circuit pack that will be reused and replace those circuit packs that have unusable
vintages. See the Hardware and Software Compatibility Matrix
Up1cku9/tsoweb/media/minhardwarevintages.pdf).
on page 101
on page 108
on page 109
on page 110
on page 122
Allowable Circuit Packs and Circuit Modules
on page 105 lists the circuit packs that cannot be used with the Avaya G650
on page 110
on page 110
on page 110
Required Migration
on page 103 lists the circuit
Non-Allowable Circuit packs and
ftp://ftp.avaya.com/incoming/
Issue 4 January 2005 101