Day Of Migration - Avaya S8700 Series Manual

Migrating legacy platforms to the Avaya S8700 or S8710 Media Server
The TN750 Announcement circuit packs are not supported in the S8700 or S8710 Media
Servers. The announcements translations will come over to the S8710 or S8710; however,
the circuit pack locations need to be changed to the TN2501AP Voice Announcement over
LAN (VAL) circuit pack.
Note:
All announcement names must be unique on a TN2501AP Voice Announcement
Note:
over LAN (VAL) circuit pack; the announcement names cannot contain any
spaces/blanks or the following characters (./:*?\<>).
Type change announcements to change any names and port locations.
On the IP Services screen, in the Service Type field, remove Alarm1 or Alarm2. You first
may need to change the System Parameters Maintenance screen before you can make
any changes to the IP Services screen.
On the Trunk Group screen, change the Measured field from measured to none to
indicate trunk group measurement reports are not required. Remember to re-measure
trunks groups.
Type list trunk-group to get a list of trunk groups that are "measured" and need to be
changed.
Check the Dial Plan (or Dial Plan Analysis Table screen depending on the release)
screen for 0 assigned as attd. If none, check the Attendant Console screens for any
buttons with atd-qcalls or attd-qtime btns. Remove these if the 0 is not assigned as attd.

Day of migration

S8710: Verify that the open, customer-supplied, EIA 310D (or equivalent) standard 4-post,
19-inch (48-centimeter) equipment rack is properly installed and solidly secured. Make
sure it is installed close to the existing S8700 Media Server to reuse the UPSs and
Ethernet switch(es).
If moving the UPSs and Ethernet switch(es) from the 2-post rack, make sure you have
- a crosspoint (Phillips) screwdriver
- rail kits for a 4-post rack for the UPSs
- cage nuts to attach the screws to the rack, if necessary
- and at least 2 people to lift the equipment
Verify that the 19-inch EIA 310D (48-centimeter) open equipment rack was grounded. See
the job aid titled Approved Grounds (555-245-772).
Verify that cabling for the TN2312BP Internet Protocol Server Interface (IPSI) circuit packs
is labeled and run from the control hardware rack to the port networks or that appropriate
connectivity is provided.
28 Migrating to the Avaya S8700 Media Server