Accessing The Maintenance Web Interface; Using The Sat Command Line Prompt - Avaya S8500 Installing And Configuring

Appendix A: Media server access
6. When the Start PPP now message appears, click Done. When you see the Connection
Complete dialog box, your computer is connected to the media server.
7. To open a Telnet session, click Start > Run to open the Run dialog box.
8. In the Run dialog box, type telnet IPaddress and click OK, where IPaddress is the
address of the active media server.

Accessing the Maintenance Web Interface

You can administer the media server through the Maintenance Web Interface. Access the
Maintenance Web Interface when connected:
over the customer's network, using MS Internet Explorer 5.5 or 6.0.
●
directly to the services port on the media server (see
●
directly to the S8500 Media Server
To access the Maintenance Web Interface, you must first bypass any proxy servers.
1. In Internet Explorer 5.5 or 6.0, Click Tools > Internet Options.
2. Select the Connection tab.
3. In the LAN Settings box (lower righthand), click Advanced.
4. In the Exceptions box after the last entry, type 192.11.13.6
5. Click OK, then OK, then OK again to close the dialog boxes.
6. Open the MS Internet Explorer Web browser to access the Maintenance Web Interface.
If connected directly, in the Address field, type 192.11.13.6.
●
If connected remotely through a modem, in the Address field, type in the IP address
●
or DNS host name of the media server.
7. When prompted, log in.

Using the SAT command line prompt

Use a direct connection to Communication Manager or a remote Secure Shell (SSH) or Telnet
session to access the SAT (System Administration Terminal) command line prompt.
SSH: To open a SSH session.
See Accessing the server's command line interface with SSH
Telnet: To open a Telnet window session.
104
Installing and Configuring the Avaya S8500 Media Server
Services laptop computer connected
on page 102)
on page 99
February 2006