Avaya S8500 Installing And Configuring page 65

2. Insert a pen, golf tee, or similar object into the recessed push button switch.
Note:
If you pass up the letter or number that you want, you have two options. You can
Note:
cycle through all the letters or numbers to get to the one you want. Or, you can
reinsert, or reseat, the circuit pack and start again.
Note:
If you have only one system, the default switch ID is A. The second system is B
Note:
and so on. The switch ID is not the media gateway or carrier letter.
3. While the display characters are flashing, press the button until the switch ID, A through J,
shows on the top character of the LED display. When the correct letter shows, stop. The
letter flashes a few times, or 5 seconds, then stops. The next character down starts to
flash.
The following steps set the cabinet number.
Note:
The number to program is the cabinet number not the port network number. If you
Note:
have more than one IPSI in a cabinet, they all have the same cabinet number.
1. While the first digit of the number is flashing, press the button until the correct tens digit, 0
through 6, shows on the display. When the correct digit appears, stop. The digit flashes a
few times, or 5 seconds, then stops. The second digit starts flashing.
Installing and Configuring the Avaya S8500 Media Server
CLK
S
E
R
V
IPSI address configuration
February 2006
65