Verifying That The Primary Controller Identifies The New Lsp; Readministering Media Gateways To Point To The Lsp - Avaya S8500 Installing And Configuring

Chapter 7: Install an S8500 Server as an LSP
Verifying that the primary controller identifies the
new LSP
1. Wait several minutes after you reset the S8500 LSP. On the primary controller, run the SAT
command list survivable-processor to verify that the LSP server registers, and
that translations are updated.
2. If the LSP is registered, the Service State? field shows in-service and the Translations
Updated field shows the time and the date of the update.
list survivable-processor
Name
LSPNYC
LSPCHI

Readministering media gateways to point to the LSP

Change the controller list for each G700, G350, or G250 Media Gateway that uses the LSP as
an alternate controller. This change enables the media gateway to seek service from the LSP if
the connection to the primary controller fails.
For how to change the controller list of the media gateway, see one of the following documents:
Installation and Upgrades for the Avaya G700 Media Gateway and Avaya S8300 Server,
555-234-100
Installation and Upgrades for the Avaya G250 Media Gateways, 03-300434
Installation and Upgrades for the Avaya G350 Media Gateway, 03-300394
72
Installing and Configuring the Avaya S8500 Server
SURVIVABLE PROCESSORS
Type ID IP Address
LSP 04 128.256.173.101
LSP 05 128.256.113.213
Page
Service Translations
State? Updated
in-service/idle 03:21 02/19/03
out-of-service 04:32 02/20/03
1 of xx
February 2007