Resetting The S8500 Lsp - Avaya S8500 Installing And Configuring

Chapter 7: Install an S8500 Media Server as an LSP
3. Click the Advanced Setting button.
The advanced firewall settings Web page appears.
4. Check that the following defaults are set:
Output to server is selected for gateway compatibility, ports 1024:65535
●
Input to server is selected for ip-signaling-1, ports 5000:5021/tcp
●
Input to server is selected for ip-signaling-2, ports 5024:9999/tcp
●
Input to server is selected for h248message, port 2945/tcp
●
Input to server and Output to server is selected for filesync, port 21874/tcp
●
Input to server and Output to server is selected for h323gatestat, port 1719/udp
●
Input to server and Output to server is selected for h323hostcall, port 1720/tcp
●
If any of the defaults are not set correctly, contact your sales representative.
5. Click the Standard Service button to return to the first Firewall page, then click Submit.

Resetting the S8500 LSP

Use the following commands to notify all processes of the new parameters:
Note:
When you access the SAT screen prior to doing a reset, the screen may indicate
Note:
a license mismatch. This is normal and will be resolved after the reset.
From the SAT command line, enter reset system 4.
The system resets. In addition, the system registers with the primary controller and receives the
translations from the primary controller.
80
Installing and Configuring the Avaya S8500 Media Server February 2006