Default IP addresses for Ethernet switch
The default values for the Ethernet switch are shown in the table.
Parameter
IP address for Ethernet switch
Subnet mask for Ethernet switch
IP address for
Trap receiver (media server)
Administer the SNMP subagent in the Ethernet switch following the steps in
Ethernet switch
Preparing to configure the Ethernet switch
Before you configure the Ethernet switch, make sure you have the hardware connected
correctly and all the information you need.
Ensure the Ethernet switch power cord is connected to the back of the switch and the back
●
of a UPS.
Note:
Avaya Terminal Emulation and HyperTerminal are supported terminal emulation
Note:
applications.
When using your terminal emulation application, ensure that your laptop communication
●
protocol has the following port settings:
- 9600 baud
- No parity
- 8 data bits
- 1 stop bit
- No flow control
If a Network Management System (NMS) is going to monitor the Ethernet switch,
●
coordinate the assignment of community names with the network administrator.
If an NMS is not going to monitor the Ethernet switch, set the community names to unique
string values.
36
Installing and Configuring the Avaya S8500 Media Server
on page 37.
Single Control
Network (CNA)
198.152.254.240
255.255.0.0
customer provided
Duplicated Control
Network (CNB)
198.152.255.240
255.255.0.0
customer provided
Configuring the
February 2006