Verifying That Ipsis Are Translated - Avaya S8710 Installing And Configuring

4 Connecting to the IPSIs

Verifying that IPSIs are translated

16
Type
17
Check the LCD. Verify that it has an I P with a filled-in V showing at the bottom. (See
LED display showing that the IPSI has a static IP address,
Figure 2: LED display showing that the IPSI has a static IP address
18
Disconnect the laptop from the faceplate.
19
Repeat for each IPSI circuit pack.
Verifying that IPSIs are translated
1
Type
2
Verify that all ISPI circuit packs are translated.
54
to logoff the IPSI.
quit
NOTE:
Control network settings (IP address, subnet mask, and gateway) become effective when
you exit the IPADMIN session.
NOTE:
Always use the arp -d 192.11.13.6 command (step 4) to clear the ARP cache on the
laptop before connecting to another IPSI. If the cache is not cleared the laptop appears to
hang and does not connect to the next IPSI.
NOTE:
You must be on the active media server to use SAT commands.
list ipserver-interface and press Enter.
Installing and Configuring the Avaya S8700 or S8710 Media Server
on page 54)
CLK
S
E
R
V
Figure 2,
June 2004