Chapter 6: IP interface configuration
2. While the second digit is flashing, press the button until the correct units digit, 0 through 9,
shows on the display. When the correct digit shows, stop. The digit flashes a few times, or
5 seconds, then stops.
3. All segments of the display go dark for one second. Then, the Switch ID and media
gateway stack number shows in the top three characters of the LED display. A "V" is
shown in the fourth or bottom character. When the DHCP server assigns an address to the
IPSI, the center of the "V" fills in. The filled in "V" looks like the bottom half of a diamond.
For duplicated control network, repeat these steps for the second IPSI in the cabinet.
66
Installing and Configuring the Avaya S8500 Media Server
CLK
S
E
R
V
February 2006