Verifying Ipsi Translations - Avaya S8500 Manual

Postmigration administration
16
Type
quit
17
Check the LCD. Verify that it has an I P with a filled-in V showing at the bottom. (See
LED display showing that the IPSI has a static IP address,
Figure 22: LED display showing that the IPSI has a static IP address
18
Disconnect the laptop from the faceplate.
19
Repeat for each IPSI circuit pack.

Verifying IPSI translations

1
Type list ipserver-interface
2
Verify that the ISPI circuit pack(s) is translated.
112
to logoff the IPSI.
NOTE:
Control network settings (IP address, subnet mask, and gateway) become effective when
you exit the IPADMIN session.
NOTE:
Always use the arp -d 192.11.13.6 command (step 4) to clear the ARP cache on the
laptop before connecting to another IPSI. If the cache is not cleared the laptop appears to
hang and does not connect to the next IPSI.
and press
on page 112)
CLK
S
E
R
V
Enter .
Migrating to the Avaya S8700 or S8710 Media Server
Figure 22,
June 2004