Ii-2-2-14 Details Page For Ipv6 - 6In4 Static Tunnel - Draytek Vigor2620 LTE Series User Manual

RIPng Protocol
After finished the above settings, click OK to save the settings.
I I - 2 - 2 - 1 4
I I - 2 - 2 - 1 4
This type allows you to setup 6in4 Static Tunnel for WAN interface.
Such mode allows the router to access IPv6 network through IPv4 network.
However, 6in4 offers a prefix outside of 2002::0/16. So, you can use a fixed endpoint rather
than anycast endpoint. The mode has more reliability.
Available settings are explained as follows:
Item
Remote Endpoint IPv4
Address
6in4 IPv6 Address
LAN Routed Prefix
Tunnel TTL
WAN Connection
Detection
88


RIPng (RIP next generation) offers the same functions and
benefits as IPv4 RIP v2.
D e t a i l s P a g e f o r I P v
D e t a i l s P a g e f o r I P v
Description
Enter the static IPv4 address for the remote server.
Enter the static IPv6 address for IPv4 tunnel with the value
for prefix length.
Enter the static IPv6 address for LAN routing with the value
for prefix length.
Enter the number for the data lifetime in tunnel.
Such function allows you to verify whether network
connection is alive or not through Ping Detect.
Mode – Choose NS Detect, Always On or Ping Detect for
the system to execute for WAN detection. Always On
means no detection will be executed. The network
connection will be on always.

Ping IP/Hostname – If you choose Ping Detect as
detection mode, you have to type IP address in this field
for pinging.
TTL (Time to Live) –If you choose Ping Detect as
detection mode, you have to type TTL value.
6 6 i n 4 S t a t i c T u n n
6 6 i n 4 S t a t i c T u n n
– –
Ping IP/Hostname – If you choose Ping Detect as
detection mode, you have to type IP address in this field
e l
e l
Vigor2620 Series User's Guide