Draytek Vigor2620 LTE Series User Manual page 571

For Dial-In Settings
<index> <itype=> <peer=>
<peerid=> <iname=>
<ipwd=> <ivj=> <ikey=>
<imeth=>
For TCP/IP Settings
<index> <mywip=>
<rgip=> <rnip=>
<rnmask=> <lnip=>
<lnmask=> <rip=>
<mode=> <droute=>
Vigor2620 Series User's Guide
MD5/ SHA1/ SHA2).
Enter ometh=espa 1/9/2 or ometh=espaa a/m/s/S 1/9/2.
(means ESP AES 128/192/256 without or with
Authentication Auto/MD5/SHA1/SHA2 (AES128/192/256)
<sch=>: Enter sch=1 ~ 15 to select schedule 1 ~ 15. (e.g.,
sch=1,3,5,7 Set schedule 1->3->5->7)
<ikemode=>: Enter ikemode=m or ikemode=a to set IKE
phase 1 mode as Main or Aggressive mode.
<ikeid=>: Enter ikeid=local ID to set IKE local ID (e.g.,
ikeid=vigor).
<index>: Enter the index number of L2L (LAN to LAN) profile.
<itype=>: see below
Enter itype=t (for PPTP)
Enter itype=s (for IPsec)
Enter itype=l (for L2TP(IPsec Policy None)
Enter itype=l1 (for L2TP(IPsec Policy Nice to Have)
Enter itype=l2 (for L2TP(IPsec Policy Must)
Enter itype=c (for SSL Tunnel)
<peer=>: Enter peer=off or peer=IP address. In which, "off"
means any remote IP is allowed to dial in. "IP address" means
to allow VPN dial-in with a specified IP address (e.g.,
203.12.23.48).
<peerid=>: Enter peerid=ID name as the peer ID for remote
VPN gateway. For example, peerid=draytek means the word
"draytek" is used as the local ID.
<iname=>: Enter iname=name as the dial-in username. For
example, iname=admin means the word "admin" is used as
the username.
<ipwd>: Enter ipwd=password as the dial-in password. For
example, ipwd=1234 means the word "1234" is used as the
password.
<ivj>: Enter ivj=on or ivj=off to enable or diable the function
of VJ Compression.
<ikey>: Enter ikey=ikey as the IKE Pre-Shared Key. For
example, ikey=abcd means the word "abcd" is used as the IKE
PSK.
<imeth=>: Enter imeth=h, d, 3, a to specify the IPsec security
method.
d, Allow AH
d, Allow DES
3, Allow 3DES
a, Allow AES
<index>: Enter the index number of L2L (LAN to LAN) profile.
<mywip=>: Enter mywip=IP address to set MY WAN IP. For
example, mywip=1.2.3.4 means the IP address "1.2.3.4" is
used as My WAN IP.
<rgip=>: Enter rgip= IP address to set the Remote Gateway IP.
For example, rgip=2.3.4.5 means the IP address "2.3.4.5" is
used as the Remote Gateway IP.
<rnip=>: Enter rnip= IP address to set the Remote Network IP.
559