Draytek Vigor2620 LTE Series User Manual page 589

wl config ratectl <ssid_num><enable> <upload download>
wl config isolate <ssid_num> <lan member>
wl config dtim <value>
wl config beaconperiod <value>
wl config radio <enable>
wl config frag <value>
wl config rts <value>
wl config rate_alg <value>
wl config country <value>
S y n t a x
S y n t a x
Parameter
mode <value>
mode show
channel <number>
preamble <enable>
txburst <enable>
ssid ssid_num> <enable>
<
<ssid_name>
<hidden_ssid>
security <SSID_NUMBER>
Vigor2620 Series User's Guide
D e s c r i p t i o n
D e s c r i p t i o n
Description
It means to select connection mode for wireless connection.
<value>: Enter 11bg, 11gn, 11bgn, 11n, 11g or 11b to set
connection mode for wireless connection.
It means to display what the current wireless mode is.
It means the channel of frequency of the wireless LAN.
<number>: Enter 0,1,2,3,4,5,6,7,8,9,10,11,12 or 13.
number=0, means Auto
number=1, means Channel 1
....
number=13, means Channel 13.
It means to define the length of the sync field in an 802.11
packet.
Most modern wireless network uses short preamble with 56
bit sync field instead of long preamble with 128 bit sync
field. However, some original 11b wireless network devices
only support long preamble.
<enable>: Enter 0 or 1.
0, disable to use long preamble.
1, enable to use long preamble.
It means to enhance the performance in data transmission
about 40%* more (by enabling Tx Burst). It is active only
when both sides of Access Point and Station (in wireless
client) invoke this function at the same time.
<enable>: Enter 0 or 1.
0, disable the function.
1, enable the funciton.
It means to set the name of the SSID, hide the SSID if
required.
<ssid_num>: Enter 1, 2, 3 or 4 to specify SSID1, SSID2, SSID3
or SSID4.
<enable>: Enter 1 or 0. 1, enable; 0, disable.
<ssid_name>: Enter a name for the specified SSID.
<hidden_ssid>: Enter 0 to hide the SSID or 1 to display the
SSID
It means to configure security settings for the wirelesss
577