Draytek Vigor2620 LTE Series User Manual page 502

INDEX -s CHK
<START_P><END_P>
INDEX -d CHK
<START_P><END_P>
E x a m p l
E x a m p
> object service obj 1 -n limit
> object service obj 1 -p 255
> object service obj 1 -s 1 120 240
> object service obj 1 -d 1 200 220
> object service obj 1 -v
Service Object Profile 1
Name
490
58, means ICMPv6
255, means TCP/UDP
Other values mean other protocols.
Example: object service obj 8 -p 1
It means to set source port check and configure port range
(1~65565) for TCP/UDP.
INDEX: Enter the index number of the specified service
object profile.
CHK: Enter 0, 1, 2, or 3
<START_P>: Enter a number as starting port number.
<END_P>: Enter a port number as the eding port number.
Example: object service obj 3 -s 0 100 200
It means to set destination port check and configure port
range (1~65565) for TCP/UDP.
INDEX: Enter the index number of the specified service
object profile.
CHK: Enter 0, 1, 2, or 3
<START_P>: Enter a number as starting port number.
<END_P>: Enter a port number as the eding port number.
Example: object service obj 3 -d 1 100 200
e
l e
:[limit]
0, means equal(=), when the starting port and ending port
values are the same, it indicates one port; when the
starting port and ending port values are different, it
indicates a range for the port and available for this service
type.
1, means not equal(!=), when the starting port and ending
port values are the same, it indicates all the ports except
the port defined here; when the starting port and ending
port values are different, it indicates that all the ports
except the range defined here are available for this
service type.
2, means larger(>), the port number greater than this
value is available.
3, means less(<), the port number less than this value is
available for this profile.
0, means equal(=), when the starting port and ending port
values are the same, it indicates one port; when the
starting port and ending port values are different, it
indicates a range for the port and available for this service
type.
1, means not equal(!=), when the starting port and ending
port values are the same, it indicates all the ports except
the port defined here; when the starting port and ending
port values are different, it indicates that all the ports
except the range defined here are available for this
service type.
2, means larger(>), the port number greater than this
value is available.
3, means less(<), the port number less than this value is
available for this profile.
Vigor2620 Series User's Guide